Accurate Technology Digi-Stop Spezifikationen PDF herunterladen (Seite 12)

Manual Part # 800-1070-001, Rev112012 Page 12 of 16

Lock Mode

To activate the Lock function Press and hold the ON/OFF key and then

momentarily press the UNITS key. The word LOCK will appear in the upper left

corner of the readout. When LOCK is displayed, the +, DATUM and – keys

become inactive to prevent accidental changes of the (calibrated) current

displayed position. To de-activate the Lock function, press and hold the ON/OFF

key and then momentarily press the UNITS key.

NOTE: The Lock function can also be enabled/disabled through programming.

This allows a more permanent Lock function since programming can be

disabled with a hardware jumper inside the readout thus preventing any front

panel programming changes.

See Section 3: Readout Programming, Programming Parameter Pr3.

Resolution

The Digital readout can be configured to display measurements in any of three

different resolutions.

1. Low– the resolution is .1in or .1mm.

2. Normal– the resolution is: .01in or .01mm.

3. High– the resolution is: .001in or .01mm

The display of fractions remains the same for all settings: 1/16, 1/32 & 1/64

See Section 3: Readout Programming & , Programming Parameter Pr4.

Incremental Measurements

The readout has two measurement modes, or indexes. One is referred to as

ABS or Absolute, and the other as INC, or Incremental. The absolute

measurement mode allows the operator to read the current position of the stop

referenced from a fixed or known position such as the saw blade.

The incremental mode allows the operator to make relative distance

measurements from one arbitrary point to another. The absolute position of

the Digi-Stop is not lost when using the incremental mode.

Absolute

The readout automatically enters ABS mode when power is first applied. This

is indicated by the ABS symbol in the upper left corner of the display. While in

the ABS mode, all stop positions are related to the current ABS, or absolute

system reference point, ie the blade..

Incremental

To enter the INC mode, press and hold the UNITS key for approximately 3

seconds. The INC symbol will appear in the upper left corner of the display.

When the INC mode is entered the readout will display zero (0) or the last offset

1 2 ... 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

Accurate Technology Digi-Stop Spezifikationen Seite 12