Accurate Technology Digi-Stop Spezifikationen PDF herunterladen (Seite 9)

Accurate Technology DigiStop Page 9 of 16

Changing the Batteries

A low battery indicator will appear in the lower left corner of the LCD. When

battery voltage drops below approximately 2.6V the readout will turn itself off

until the batteries are replaced.

To replace the battery remove the screws in the upper right and lower left

corners. Pull the cover off. Remove the old batteries. Reinstall 2 new AA

Alkaline batteries, noting the proper orientation. Replace the cover and tighten

the screws.

CAUTION: DO NOT BEND THE BATTERY CLIPS!

THESE CLIPS ARE DESIGNED TO BE LOOSE WHEN THE CASE

IS OPEN AND WILL COMPRESS AND SECURE THE BATTERIES

IN PLACE WHEN THE CASE HALVES ARE SCREWED TOGETHER.

The LCD Display

The

above figure illustrates all the segments available on the LCD.

(Not all segments are used on Digi-Stop Systems)

Pressing and holding the ON/OFF and UNITS key for 10 seconds with power off

will perform a full segment LCD test, display the current firmware version, and

RESET ALL PROGRAMMING PARAMETERS TO FACTORY DEFAULTS.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

Accurate Technology Digi-Stop Spezifikationen Seite 9